I took some RC plane transmitter, since they are more anatomical correct and they sure do look better, and started change.
But from the beginning problem poped up; HL transmitters eletrical board is too big/long. To remedy this I needed to chop it in two pieces so that it can fit. Fortunately board has two parts; one for commands/switches and second one (smaller one) for antenna eletronics. Now, I am talking about one piece board, but it is devided in two eletrical circuits. They are connected with two-three wires so that wont be a problem to reconnect.
(I don´t have circuit board with me to take a photo of it, since this one is cut in half, and one of Bergetiger is flipped and hot glued)
Also, reconnecting that A-B-C switch was a challange, but as you´ll see it was worth it.
P8020468.JPG
Compared to standard HL transmitter.
P8020469.JPG
Battery pack is on bottom.
P8020470.JPG
Red arrow shows three micro switches for programing tank.
P8020471.JPG
Red arrow is for A-B-C switch.
P8020474.JPG
Red arrow is for switch part of board, and blue is for antenna part.
I used small copper wires coated with lacquer for isolation, thus minimizing resistance.Statistics: Posted by kamaz — Tue Aug 02, 2011 10:43 pm
]]>