These are the setting for a Mode 2 Spektrum...
RCtoHL(ver1.4) stick DX6i(mod-2).jpg
If using a 6 channel receiver with the newer RC2HLs you can remove the jumper that is above the RX18 input.
Check that the cables are connected correctly with the signal wire to the inside of the RC2HL board.
Turn radio on FIRST then the tank and wait until the LED on the RC2HL lights up before trying to turn on the tank.
Make sure that there are no mixes appiled and that each channel is outputting the full range of movement.
Good Luck...Statistics: Posted by Phyrephish — Sat May 04, 2013 2:42 pm
]]>