Mode 1 vs Mode 2
Turnigy 9XR (Stock Firmware) with Orange RX DSM2 and Orange 6CH TX (Mode 2)
Connections to the RC2HL for Mode 2 as above.
MIXER
CH1 100% THR c1 (link your throttle to curve 1)
CH2 100% AIL
CH3 100% ELE
CH4 100% RUD
REVERSE
CH1 REV
CH2 REV
CH3 REV
CH4 REV
CURVES
CV1 -100 -8 50 100 100
Throttle Trim on lowest setting.
Spectrum DX8 with Orange 6CH TX (Mode 2)
Connections to the RC2HL for Mode 2 as above.
SERVO SETUP
Throttle Travel:
100% 140%
Reverse:
NOR Throttle
REV Aileron
NOR Elevator
NOR Rudder
Throttle Curve:
Low 0%
25% 84%
50% 84%
75% 84%
High 100%
Throttle Trim on lowest setting.
Walkera Devo F4 with Devention 6CH Receiver(Mode 2)
Connections to the RC2HL for Mode 2 as above.
Reverse Switch:
REV Elevator
NOR Aileron
REV Throttle
NOR Rudder
Travel Adjust:
Throttle:
H100.0
L130.0
Rule of Thumb:
1. Always turn on your transmitter first.
2. Center your throttle stick.
3. Turn on your tank and wait a few seconds.
4. Start your tank.
May the force be with you... always...Statistics: Posted by vorstertp — Thu Aug 08, 2013 4:09 am
]]>