http://www.hobbyking.com/hobbyking/stor ... apter.html
I will be ordering one to take apart
. I suspect that with a little mod it could also be used to update RCTA units. All that would be required is to separate the TX and RX signals.Cheers
KG
Statistics: Posted by Phyrephish — Sat May 14, 2016 6:59 am
]]>
Secondly the 9XR Pro running ersky9x comes with "Maintenance Mode" which is enabled when you hold both horizontal trims AWAY from the centre while powering on. If you place the update firmware in the firmware folder on the SD card you can connect your custom cable to the radio and update using the radio.
Like the droneshop if you are still unsure of how to make up the cable - just ask and I can make on for you. I may even include such an option of on the RCTA update boards I am working on.
Cheers
KG
Statistics: Posted by Phyrephish — Mon May 09, 2016 7:32 am
]]>
Simple solution. Get the x8r flashed to International firmware to match the Turnigy.
Beyond my capabilities but the Droneshop in the UK carries out flashing of the x8r (and the xjt module if you want.)
This link should explain.https://m.youtube.com/watch?v=AnDTJ0bwG2E
Statistics: Posted by tanku — Mon May 09, 2016 1:47 am
]]>
Backed up the radio to the computer then did the firmware update (much easier than the 9X) and the models still there.
Got all the receivers bind up no problem with the firmware corrected. Tomorrow will get the receivers installed in the models.
Thanks again Kevin.
Ian.
Statistics: Posted by Tankbear — Tue Nov 17, 2015 8:14 am
]]>
If you install eePskye then each time you start eePskye it will look for the latest firmware version automatically for you. Or you can go - HELP -> Check for updates
Here is the latest file I have downloaded on the 13th Nov
ersky9xr_rom_13Nov15.zip
Unzip - place in firmware folder on sd card
Press the 2 inner most horizontal trim buttons while turning on radio
Radio will start in bootloader mode
Select the updated firmware - MENU MENU
Restart
I'm fairly sure that all your models will be ok - BUT then to be really sure you can always back them up. Select each model then choose BACKUP from the menu. Your model files will be written as .eepm files in a folder called "models" on your SD Card. IF anything does go wrong you use RESTORE to bring them back.
Also you can do a full backup of the radio using eepskye
Yes a re- calibration always to be sure
Cheers
KG
Statistics: Posted by Phyrephish — Tue Nov 17, 2015 8:05 am
]]>
Me again. I don't get the bind option in my menu. Using ersky9x_Rom_R204 firmware so guess that is the issue, wasn't fussed to change to tank firmware as won't use controller on tanks.
If I change firmware will my model sets still work okay, just need radio calibration?
And where's firmware for 9XR Pro as I can't find it.
Cheers
Ian.
Statistics: Posted by Tankbear — Tue Nov 17, 2015 5:00 am
]]>
No problems here
Nevertheless every RCTA video will also be on the youtube channel
www.yuotube.com/rctanksau
cheers
KG
Statistics: Posted by Phyrephish — Tue Jan 20, 2015 11:00 pm
]]>
Cheers
Gra
Statistics: Posted by Gra — Sat Jan 17, 2015 1:37 pm
]]>
Cheers
Admin
Statistics: Posted by Admin — Thu Jan 15, 2015 7:43 am
]]>