on eBay
http://www.ebay.com/sch/i.html?_odkw=ma ... acat=12576
Very important DO NOT CONNECT to 5V. The 3 program wires are RX, GND & TX in that order. GND is the middle pin. You must power Asp separately. This way you can not fry the controllers by incorrect connection of the program cable. With GND as the middle pin - if you connect TX and RX around the wrong way all that will happen is that you get a message that the device was not found on the COM port. Swap cable around to fix.
Cabling is however, PART B - you need to get PART A done first.
1. install the FTDI breakout and set onto COM port 5
2. Use the FTProg utility to apply the correct template to the FTDI chip
(I'm sure that I have sent it to you "TheWorkingCable")
Only once you have done these two first you can get onto the cable. OF course there is no reason why you can not solder your own permanent or temporary type connector to the ports.
Cheers
KG
Statistics: Posted by Phyrephish — Wed Nov 11, 2015 8:43 am
]]>
thanks for any help
Statistics: Posted by ranman38 — Tue Nov 10, 2015 1:03 pm
]]>
]]>
If you have managed this update then you are set. I hope you have had no problem with disk images. If not familiar with the concept then is can be a bit different to usual file transfer stuff.
Next step is to document what each of the 180+ sounds on Asp is for and the guides for changing them.
Cheers
KG
Statistics: Posted by Phyrephish — Wed Jul 15, 2015 8:55 am
]]>
Works like a dream now , thx U for efforts , its a fantastic read understanding it all..very interesting indeed
cheers
Andy
update: 16/6/2015
Just to let U know Kevin, My ASP plus package arrived safe and sound this morning. Highly delighted .. Its a very complete system indeed , a must for all RC Tank owners everywhere
Statistics: Posted by Jaguk — Tue Jun 16, 2015 9:04 am
]]>
Please try again...
TESTED - all good here
Cheers
KG
Statistics: Posted by Phyrephish — Tue Jun 16, 2015 8:32 am
]]>
I dont know if its me but is anyone else having problems unzipping Module_B file, Im getting an end of file error ?
Andy
Statistics: Posted by Jaguk — Tue Jun 16, 2015 3:51 am
]]>
]]>