Battled with elmod and elmod BU , ibu2 with hl BU and original tamiya BU..... and it is no fun to fight each other from a few Meters just. ....
Or is the Best way all of the guys use Piranha??
Cheers
Statistics: Posted by robtronic — Wed Jun 21, 2017 4:13 pm
]]>
]]>
Statistics: Posted by Peregrine — Thu Jun 15, 2017 9:02 am
]]>
]]>
Maybe more easy for me to understand
And also wanna know how to fit in the ir Emitter led.
Cause wanna use it with elmod , and have only 5 pins ( But know which pin is for which use )
BeSt regards , Robert
Statistics: Posted by robtronic — Tue Jun 13, 2017 6:41 pm
]]>
Every electrical component you buy will have a datasheet - find/download it and it will tell you what pins are what. I don't have that particular data sheet on hand but even though there are 4 pads there is in fact only 3. Both outer pads are ground V0. I'm sure it will work if you only solder a wire to one of the outer grounds (you don't need both connected).
You will find that multiple ground pads are quite common on SMD components.
Cheers
Kevin G
Statistics: Posted by Phyrephish — Mon Mar 06, 2017 6:34 am
]]>
]]>
Yes the ones I use will fit in just about all of the vison ports. Was planning to do that with my latest KV-1 build but in the end decided too much trouble with wiring
Two types - This one may be better in the ports as it has a flat face
http://au.rs-online.com/web/p/ir-receivers/7733899/
This is the regular type
http://au.rs-online.com/web/p/ir-receivers/7689360/
On a KV-1 they would work quite well as they can sit on the top of the hull but for vision ports in cupolas then you need a circuit board.
Cheers
KG
Statistics: Posted by Phyrephish — Tue Feb 28, 2017 6:48 am
]]>
My idea is to hide the sensors in the turret vision ports.
Thanks
Statistics: Posted by Rad_Schuhart — Tue Feb 28, 2017 2:36 am
]]>
]]>
]]>
]]>