| RC Tanks Australia Forum http://www.rctanksaustralia.com/forum/ | |
| 9XR Pro Programming Help http://www.rctanksaustralia.com/forum/viewtopic.php?f=117&t=1044 |
Page 1 of 1 |
| Author: | Tankbear [ Sat Nov 07, 2015 8:34 pm ] |
| Post subject: | 9XR Pro Programming Help |
Hi Guys, I've a 9XR Pro with standard firmware which I'm using for a RC excavator, but I'm a bit stuck on something. At the moment I have a brushless ESC connected to channel 5 which is assigned a rotatory knob, channels 6, 7, 8 have servos attached to the hydraulic valve block to control the pistons. channels 6,7, 8 are programmed on the thumb sticks. So currently I turn the knob about 1/4 turn to get about 25% throttle on the pump ESC then I can play around with the thumb sticks to get the pistons moving. But I want to try this setup. When ever I move thumb sticks (channels 6,7, 8) the pump automatically start at 25% I tried adding mixing to channel 5 but it doesn't work for when I move a stick left or down only right or up plus it appears to take the sum of all 3 sticks so can get 75% in some stick configurations. I'm sure I'm missing the obvious but any suggestions welcome. Ian. |
|
| Author: | Tankbear [ Mon Nov 09, 2015 6:12 am ] |
| Post subject: | Re: 9XR Pro Programming Help |
Hi guys, Figured it out, guy on another forum sent me a eepe file to view and figured out I need to add a curve profile to the command lines. Ian. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ | |