RC Tanks Australia Forum http://www.rctanksaustralia.com/forum/ | |
ASP REMORA connection http://www.rctanksaustralia.com/forum/viewtopic.php?f=164&t=1004 |
Page 1 of 1 |
Author: | mikeb [ Tue Jun 30, 2015 6:24 pm ] |
Post subject: | ASP REMORA connection |
Its most likely obvious but where does the remora connect to the ASP? Mike |
Author: | Phyrephish [ Tue Jun 30, 2015 10:37 pm ] |
Post subject: | Re: ASP REMORA connection |
Look underneath the Juno board...... There will be a 3 pin header or maybe not. Regardless below the Remora's tail is the signal pin, middle pin is V+ and pin closest to centre is V0 Again all clearly marked The header may not be there because if there is no Remora attached the V+ and V0 pins are exposed and could be shorted. ALSO As you will see using a servo connector the plug may interfere with the separate Turret & Elevation motor connections. My bad ![]() 2015_Asp_Remora.jpg Cheers KG |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |