| RC Tanks Australia Forum http://www.rctanksaustralia.com/forum/ | |
| ASP - Activating rear/reverse light http://www.rctanksaustralia.com/forum/viewtopic.php?f=164&t=989 |
Page 1 of 1 |
| Author: | Phyrephish [ Sun May 31, 2015 3:29 pm ] |
| Post subject: | ASP - Activating rear/reverse light |
It has come to my attention that I have forgotten to demonstrate how to activate the reverse light on ASP. The reverse light is activated by putting a blob of solder across a solder jumper on the board. Yes you will need a soldering iron but then for 99% of rear light installs you will need one anyway. Asp has two jumpers depending on your motor setup. Fortunately 90% of setups will require the same jumper to be bridged. The required jumper is shown below rearlightactivate.jpg The first ASP shipped will NOT have this jumper bridged - I will be bridging this jumper for future shipments. If you have a tank in the 10% where this is the wrong jumper you will have to remove the solder and put a blob of solder on the solder jumper immediately above. Cheers KG |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ | |