Ok i Just got it working
The green light is on and sorted
Time to play with my tank
| RC Tanks Australia Forum http://www.rctanksaustralia.com/forum/ | |
| No green light on RC5HL board http://www.rctanksaustralia.com/forum/viewtopic.php?f=3&t=1025 |
Page 1 of 1 |
| Author: | INTELL19ENCE [ Sun Sep 06, 2015 8:42 pm ] |
| Post subject: | No green light on RC5HL board |
Hi i could not find it on here and i hope i can explain this properly but here goes: OK have a heng long tiger tank with a 9x 2.4ghz transmitter and 9x receiver to a RC5HL (new one)so they change the frequency over from 24mhz to GHz, The power light comes on however the green light does not come on, i have properly bind the Tx to the RX i have watched where 13245 pins go in to the rc5hl I am at a loss i know the green LED needs to come on so i can then start it, the red LED and Blue LEDs come on and such so what next. the setup is on to a bog standard heng long rx18 board HELP!!! |
|
| Author: | Phyrephish [ Mon Sep 07, 2015 6:55 am ] |
| Post subject: | Re: No green light on RC5HL board |
Hi There Sorry to hear you are having troubles. You do not say in your post what firmware you are running on the 9X. Are you running ER9X/tankER9X or are you running the factory firmware? The green LED on the RC5HL will only come on if it detects valid signals from ALL 5 channels from your receiver. Although you may have bound the receiver correctly have you checked using a servo for example that you are infact sending out signals on ALL 5 channels. If using the factory firmware setting up a new model may I think default to a 4 channel mix and unless you have told your radio to do so - nothing will be output on CH5 and hence the LED will not come on. You would need to setup a 5 channel mix. Then verify that you are sending out on all 5 channels. If using tanker9X setup is simple 1. In Radio Mode set your channel order to RTEA 2. Change stick mode to Mode 3 (throttle on right) 3. Create a new model 4. Go to templates and select the RC5HL template Cheers KG |
|
| Author: | INTELL19ENCE [ Mon Sep 07, 2015 12:17 pm ] |
| Post subject: | Re: No green light on RC5HL board |
Hi Thanks for that so I would have to say it is on stock firmware, i bought it brand new how can I set up a 5 channel mix? as it is stock firmware do you set it up via the aux display, then change channel 5 from null to gear for example and then look at display to check it works and then turn the tank on? this is what i have tried and so far no success (I jumped in to the deep end with this one) Thanks Seb |
|
| Author: | INTELL19ENCE [ Tue Sep 08, 2015 10:06 am ] |
| Post subject: | Re: No green light on RC5HL board |
Ok i Just got it working The green light is on and sorted Time to play with my tank |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ | |